Our OM Series load cell signal conditioners are used when a digital display is not needed, such as applications which the weighing system is controlled or monitored by a computer or PLC. These units supply the needed excitation voltage to power up to four 350 ohm bridge load cells. The wide range of models offered provide a variety of accuracy and frequency response levels, and signal outputs such as 0-10VDC, +/-10VDC, 4-20mA, RS232, RS485, and frequency. DC powered units are also available.
The rugged epoxy encapsulated design allows for use in the harshest of environments.

Below is a reference table to choose the appropriate model for your application, or simply contact us with your application information.

Output	Amplifier	Power Required	Model Number	Input Range	No. of 350 Ohm Bridges@ 10V Exc.	Bandwidth
0-10VDC	Isolated	115VAC  (220VAC Option)	OM-10	5mV-50mV	4	10Hz
0-10VDC	Non-Isolated	115VAC (220VAC Option)	OM-1	10mV-250mV	3*	3 Hz
			OM-2	40mV-250mV	3*	2 kHz adjustable
4-20mA	Isolated	115VAC (220VAC Option)	OM-13	5mV-50mV	4	10 Hz
4-20mA	Non-Isolated	115VAC (220VAC Option)	OM-3	10mV-50mV	3*	3 Hz
4-20mA, 0-20mA	Non-Isolated	10-36VDC	OM-4	3mV-62mV	5	10 Hz
0-10VDC,  +/-10VDC & 4-20mA	Non-Isolated	24VDC	OM-19	0.15mV/V to 12.5mV/V	4 w/5VDC excitation	20kHz unfiltered 10Hz filtered Jumper selectable
0-10VDC Nominal	Non-Isolated	24VDC	OM-5	Fixed Gain See spec. sheet	1	10Hz
0-10VDC	Non-Isolated	24VDC	OM-25	10-30mV	1	10Hz
4-20mA	Non-Isolated	24VDC	OM-26	10-30mV	1	10Hz
RS232 & +/-10VDC	Isolated	115VAC (220VAC Option)	OM-232-10	+/-5.5mV/V	4	60Hz
RS232 & +/-10VDC & Display	Isolated	115VAC (220VAC Option)	OM-232-D	+/-5.5mV/V	4	60Hz
RS232, RS485 Modbus or ASCII	Isolated	95-240VAC (10-48VDC Option)	VPT	Various See data sheet	4	60Hz

*External resistor may be added to drive four 350 ohm bridges at 10 volts.